Concrete Contractor in San Martin, CA - Driveways and Slabs Built on a Solid Base

Premium Gilroy Concrete is a concrete contractor based in Gilroy that pours driveways, patios, slabs and foundations in San Martin, with the base, reinforcement and drainage worked out before the truck arrives.

Concrete patio with a light gray square pattern holds outdoor chairs and a dining table beside a house.

Concrete work on San Martin properties

San Martin sits between Morgan Hill and Gilroy, where we're based, and the properties here run bigger and more spread out than in either city. On our jobs here we see houses set well back from the road, long driveways, shops and outbuildings on their own slabs, and homes out toward the foothills next to small vineyards. That mix usually means more square footage per job and a lot more open ground around it.

Price here mostly comes down to how much concrete the job needs, how much digging and base work goes under it, and how close the truck can get, and the schedule turns on the dig-out and the cure more than on the pour itself. The estimate shows you each of those lines. On a long driveway, water has a lot of ground to cross before it reaches the slab, so where it runs is the first thing I look at.

What happens when you call us about a San Martin job

  1. Call or send the form

    Tell us what you want poured and where it sits on the property, by phone at (408) 427-8265 or through the form, and we'll set a time for me to come out. A few photos of the old slab help me arrive knowing what to look for.

  2. I measure and check underneath

    I measure the job myself and look at what's under and around it, including where water runs and how the truck will reach the pour, and walking it with me helps if you can be there. Then I write the estimate line by line, so you can see what's in it and what isn't.

  3. We agree on the layout

    Before the pour we go over the plan with you, including where the control joints go, which are the cuts that decide where the slab cracks, and which way the slab falls so water drains away from your house. Nothing gets poured until you've seen it.

  4. Pour, cure and hand over

    On pour day I'm on site, and our crew works to the plan we agreed on, then cures the new concrete by keeping it covered and undisturbed while it gains strength. We hand it over once it's ready and tell you when it can take foot traffic and when it can take a car.

Concrete work we do in San Martin

Most calls from San Martin are for long driveways, patios off the back of the house, and slabs and footings for shops, garages and outbuildings on bigger lots. A concrete patio is often the first project people call about, and the list below covers the rest of what we pour here.

Does your San Martin driveway or patio need attention?

On long driveways and big slabs, a small problem can spread across a lot of concrete before anyone notices, so these signs are worth a walk around your property.

  • Cracks that keep getting wider
  • A slab sinking at the edges
  • Water pooling against the house
  • Chipping or a dusty, flaking top
  • Uneven panels that catch your feet
  • A gap between slab and foundation

Should you repair or replace a San Martin slab?

A hairline crack in a slab that still sits flat is usually worth sealing and leaving alone, because the concrete is still doing its job and the crack only lets water in. Light chipping on the surface can often be repaired the same way, as long as the concrete under it is sound.

When a panel has sunk, rocks underfoot or tips water toward your house, the problem is almost always the subgrade, the packed ground the slab sits on, and patching the top won't reach it. In that case I'd rather replace the section, dig out the soft base and pack a new one than sell you a repair that settles again. Sometimes we only know how far the damage goes once the old concrete is up.

Hiring a local concrete crew for San Martin

We're licensed and insured, and Gilroy is close enough that I can come out to measure the job myself and be back on site for the layout and the pour. Our own crew does the work, so the people pouring your slab are the ones who heard the plan, and you have one person to call with a question.

When a budget gets tight, the base is usually the first thing people want to cut, because nobody sees it once the concrete is down. I push back on that. A broom finish, the light texture that gives shoes and tires grip, looks the same on a bad base as on a good one for a while, but only the base decides whether the slab stays flat. I'd rather trim the finish than the ground under it.

Our word to San Martin homeowners

I'd rather settle questions on paper than fix them after the truck leaves, so you'll see the layout, the joint lines and where the water goes before we pour. The estimate is written line by line, so you know what you're paying for and what isn't included.

On site, our crew keeps the truck and the forms where we agreed, works around your yard and protects the new slab while it cures. If something under the old concrete changes the plan, I tell you before we keep going. Your satisfaction, guaranteed.

You'll see every line of the estimate and approve the layout before the pour, and our crew cleans up before we hand it over.

Get your San Martin concrete job measured

Call (408) 427-8265 any day of the week, since we take calls on weekday evenings and weekends, and we'll set a time to come out.

A line-by-line estimate for your San Martin job

Tell us what you want poured and where it sits on your property. We reply within one business day to set up a free on-site estimate, with no pressure to book.

(408) 427-8265

San Martin concrete questions

How do I know if my concrete contractor in San Martin needs a state license?

Your contractor needs a license from the California Contractors State License Board if the job needs a building permit, uses any workers beyond the person doing it, or adds up to $1,000 or more in labor and materials. Breaking a bigger driveway or patio into smaller contracts under that amount doesn't get around the rule, and the only exemption covers small jobs with no permit, no employees and no claim in ads to be licensed. We're licensed and insured.

How much can a contractor ask for up front on a concrete job in California?

The state licensing board caps the down payment on home improvement work, and $1,000 is the most it allows, with a lower cap on smaller contracts. After that, every payment has to be listed in the contract and match work already done or materials already delivered to your house. It's worth checking any contract against that before you sign.

Can I cancel a home improvement contract by email in California?

Yes, the state's contractor rules let you cancel a home improvement contract by email, and they require the contractor's email address to be written into the contract. Look for that address in the paperwork before you sign, so you know where to send it if you ever need to.

How much does a concrete driveway cost in San Martin?

A San Martin driveway's cost comes mostly from its size and thickness, how much old concrete or soft ground has to come out, and how far the truck has to reach on a long lot. Rebar, the steel grid inside the slab that holds cracks tight, adds to the price, and so does a decorative finish in place of a plain broom finish. I measure on site and write the estimate line by line, so you see your own number and what's in it.

Do I need a permit for a concrete driveway or patio in San Martin?

That depends on the job, so before we start I check with the office that covers your address, since the rules differ from place to place. When a job needs a permit, we pull it and line up the inspections as part of the work.

What causes concrete driveways in San Martin to crack?

Most driveway cracks come from a base that was raked level instead of dug out and packed, or from control joints that were cut late or skipped, so the slab cracked wherever it wanted. A slab that falls toward the house instead of away from it makes both problems worse. Concrete can still crack, but with a packed base, joints laid out before the pour and a proper cure, the cracks usually stay in the joints where we put them.

Don't see your city? Call us

Pick another city below, or call (408) 427-8265 if yours isn't listed, since we take work in many of the cities around Gilroy.

Call (408) 427-8265